Autocom Serial Changes Serial Number Still OK

I now have sound as well:D can you please post a picture of soldering and recycled speaker.

Autocom Serial Changes Serial Number Still OK

I do have the Keygen, is the serial number still OK As far as the firmware, the only way I can see the unit receiving a firmware is if it is Online in some way 2011 r3 do not go online.

At the rear of the mini SD socket, the track nearest the edge of the PCB (the one the goes to the SMD resistor at the side of the 8 pin IC next to the CAN filter) is supposed to be switched to GND when a card is inserted.

Anyway, I soldered the track to GND and powered the clone up with the card already inserted.

Everything appears to work now (had it logging data from a Z16SE Opel ECU on the bench anyway).

I had to glue this to the other side of the PCB because my naff case was too small.

Does anyone know what the MCU is and is it readable (all markings have been scratched off on mine).

Thanks for idea. ( I need usb connection for update firmware ).

It cannot comunicate with Ford Focus 1.6Petrol ECU.

It communicate with all other modules but with ECO dont.

Any suggestions It is old style ATocom with bluetooth antenna and blue OBD connector Ford is MY 1999-2001 If it is, then probably your Atocom clone is without OKI chip.:dontknow: Try diagnose just with OBD, that will bring you OBD (if any) errors of engine.

I cannot to diagnose this car using standard OBD protocol What is production year of that Focus:hmmmm2.

I cannot to diagnose this car using standard OBD protocol check the 2 can line transceivers the 2 beside the common mode chokes check smt relays.